DisplayLink DisplayLink Network Adapter NCM - two ways of downloading and installing the driver

DisplayLink Network Adapter NCM is a Network Adapters device. This Windows driver was developed by DisplayLink. The hardware id of this driver is USB/VID_17E9&PID_4374&MI_05.

1. DisplayLink DisplayLink Network Adapter NCM driver - how to install it manually

1. Download the setup file for DisplayLink DisplayLink Network Adapter NCM driver from the link below. This download link is for the driver version 10.2.6854.0 released on 2022-03-08.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver is digitally signed.
Driver file size: 66057 bytes (64.51 KB)
This driver received an average rating of 4.5 stars out of 49067 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 7 32 bits
• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. The easy way: using DriverMax to install DisplayLink DisplayLink Network Adapter NCM driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the DisplayLink DisplayLink Network Adapter NCM driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.