Mobile Connector Device Diagnostic Interface how to download and install the driver

Device Diagnostic Interface is a Ports device. This driver was developed by Mobile Connector. USB/VID_1C9E&PID_9404&MI_00 is the matching hardware id of this device.

1. Mobile Connector Device Diagnostic Interface driver - how to install it manually

1. Download the setup file for Mobile Connector Device Diagnostic Interface driver from the location below. This download link is for the driver version 2.0.5.3 dated 2008-07-31.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite easy to follow. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the fresh driver, it is as simple as that.
8.  

This driver is digitally signed by the manufacturer.
Driver file size: 61050 bytes (59.62 KB)
Driver rating 5 stars out of 42542 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 2000 32 bits
• This driver works on Windows Server 2003 32 bits
• This driver works on Windows XP 32 bits
• This driver works on Windows Vista 32 bits
• This driver works on Windows 7 32 bits
• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. How to use DriverMax to install Mobile Connector Device Diagnostic Interface driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's see!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Mobile Connector Device Diagnostic Interface driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.