DERMALOG Identification Systems GmbH DERMALOG Experimental Device - two ways of downloading and installing the driver

DERMALOG Experimental Device is a USBDevice device. The developer of this driver was DERMALOG Identification Systems GmbH. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_1FBA&PID_0006.

1. Manually install DERMALOG Identification Systems GmbH DERMALOG Experimental Device driver

1. Download the driver setup file for DERMALOG Identification Systems GmbH DERMALOG Experimental Device driver from the location below. This is the download link for the driver version 2.1.0.2113 dated 2021-04-06.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control Service (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite easy to follow. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is digitally signed by DERMALOG Identification Systems GmbH.
File size of the driver: 4977599 bytes (4.75 MB)
This driver was installed by many users and received an average rating of 4.1 stars out of 54539 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. The easy way: using DriverMax to install DERMALOG Identification Systems GmbH DERMALOG Experimental Device driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's see!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the DERMALOG Identification Systems GmbH DERMALOG Experimental Device driver. Click the Update button.
4.  
5. Finished installing the driver!
6.