Allied Telesis K.K. Corega CG-WLUSB300NS - two ways of downloading and installing the driver

Corega CG-WLUSB300NS is a Network Adapters device. This driver was developed by Allied Telesis K.K.. USB/VID_07AA&PID_0056 is the matching hardware id of this device.

1. Manually install Allied Telesis K.K. Corega CG-WLUSB300NS driver

1. Download the driver setup file for Allied Telesis K.K. Corega CG-WLUSB300NS driver from the link below. This is the download link for the driver version 1015.4.412.2012 released on 2012-04-20.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty easy to follow. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.
The file size of this driver is 501643 bytes (489.89 KB)
Driver rating 3.4 stars out of 9643 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 7 32 bits
• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. How to install Allied Telesis K.K. Corega CG-WLUSB300NS driver using DriverMax

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's take a look!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you find the Allied Telesis K.K. Corega CG-WLUSB300NS driver. Click the Update button.
4.  
5. Finished installing the driver!
6.