ad-block

Advertising seems to be blocked by your browser.

The ads help us provide this software and web site to you for free.

Please support our project by allowing our site to show ads.





Conceptronic Conceptronic 802.11n PC-Card V2 how to download and install the driver


Conceptronic 802.11n PC-Card V2 is a Network Adapters hardware device. The Windows version of this driver was developed by Conceptronic. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_1814&DEV_0701&SUBSYS_3C901948.

1. Manually install Conceptronic Conceptronic 802.11n PC-Card V2 driver


  1. You can download from the link below the driver setup file for the Conceptronic Conceptronic 802.11n PC-Card V2 driver. The archive contains version 3.00.00.0041 dated 2009-02-17 of the driver.
  2.  
  3. Start the driver installer file from a user account with the highest privileges (rights). If your UAC (User Access Control) is started please accept of the driver and run the setup with administrative rights.
  4.  
  5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
  6.  
  7. When the operation finishes shutdown and restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
  8.  
There is no digital signature available for this driver.
File size of the driver: 267407 bytes (261.14 KB)
This driver was rated with an average of 4 stars by 27387 users.
This driver will work for the following versions of Windows:

  • This driver works on Windows 7 32 bits
  • This driver works on Windows 8 32 bits
  • This driver works on Windows 8.1 32 bits
  • This driver works on Windows 10 32 bits
  • This driver works on Windows 11 32 bits



2. Using DriverMax to install Conceptronic Conceptronic 802.11n PC-Card V2 driver


The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

  1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
  2.  
  3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Conceptronic Conceptronic 802.11n PC-Card V2 driver. Click the Update button.
  4.  
  5. That's all, the driver is now installed!
  6.  

Drivers

ad-block

Advertising seems to be blocked by your browser.

The ads help us provide this software and web site to you for free.

Please support our project by allowing our site to show ads.