Hauppauge Colossus Encoder Device - two ways of downloading and installing the driver

Colossus Encoder Device is a MEDIA device. The developer of this driver was Hauppauge. PCI/VEN_1745&DEV_3000&SUBSYS_D1800070 is the matching hardware id of this device.

1. Hauppauge Colossus Encoder Device - install the driver manually

1. Download the driver setup file for Hauppauge Colossus Encoder Device driver from the location below. This download link is for the driver version 1.8.31093.0 dated 2013-04-03.
2.  
3. Start the driver setup file from a Windows account with administrative rights. If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, it is as simple as that.
8.  

This driver is not digitally signed.
Download size of the driver: 0 bytes (0 B)
This driver was rated with an average of 3.7 stars by 89754 users.

2. Using DriverMax to install Hauppauge Colossus Encoder Device driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Hauppauge Colossus Encoder Device driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.