Download and install Realtek Chicago173 driver

Chicago173 is a Network Adapters hardware device. The developer of this driver was Realtek. The hardware id of this driver is USB/VID_1025&PID_104E&REV_3000; this string has to match your hardware.

1. Install Realtek Chicago173 driver manually

1. Download the driver setup file for Realtek Chicago173 driver from the link below. This is the download link for the driver version 10.25.0704.2018 dated 2018-07-04.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

Realtek applied a digital signature to this driver.
File size of the driver: 288631 bytes (281.87 KB)
This driver was rated with an average of 4.2 stars by 98407 users.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. The easy way: using DriverMax to install Realtek Chicago173 driver

The advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the Realtek Chicago173 driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.