Blackmagic Design Blackmagic ATEM 2 M/E Production Switcher - two ways of downloading and installing the driver

Blackmagic ATEM 2 M/E Production Switcher is a MEDIA device. The developer of this driver was Blackmagic Design. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_1EDB&PID_BD5C.

1. Blackmagic Design Blackmagic ATEM 2 M/E Production Switcher - install the driver manually

1. Download the driver setup file for Blackmagic Design Blackmagic ATEM 2 M/E Production Switcher driver from the location below. This is the download link for the driver version 10.2.0.0 dated 2014-08-26.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be pretty straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.
Download size of the driver: 0 bytes (0 B)
Driver rating 3.5 stars out of 70143 votes.

2. How to use DriverMax to install Blackmagic Design Blackmagic ATEM 2 M/E Production Switcher driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's see!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Blackmagic Design Blackmagic ATEM 2 M/E Production Switcher driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.