Blackmagic Design Blackmagic ATEM 1 M/E Production Switcher how to download and install the driver

Blackmagic ATEM 1 M/E Production Switcher is a MEDIA hardware device. This driver was developed by Blackmagic Design. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_1EDB&PID_BD48.

1. Manually install Blackmagic Design Blackmagic ATEM 1 M/E Production Switcher driver

1. Download the setup file for Blackmagic Design Blackmagic ATEM 1 M/E Production Switcher driver from the location below. This is the download link for the driver version 10.1.0.0 dated 2014-03-26.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

There is no digital signature available for this driver.
Download size of the driver: 0 bytes (0 B)
This driver received an average rating of 3.3 stars out of 45094 votes.

2. The easy way: using DriverMax to install Blackmagic Design Blackmagic ATEM 1 M/E Production Switcher driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Blackmagic Design Blackmagic ATEM 1 M/E Production Switcher driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.