EWA Technologies, Inc. Blackhawk USB560 JTAG Emulator driver download and installation

Blackhawk USB560 JTAG Emulator is a MDPJTAG hardware device. This driver was developed by EWA Technologies, Inc.. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_0B1E&PID_8007&REV_0100.

1. How to manually install EWA Technologies, Inc. Blackhawk USB560 JTAG Emulator driver

1. You can download from the link below the driver installer file for the EWA Technologies, Inc. Blackhawk USB560 JTAG Emulator driver. The archive contains version 3.2.1.8 dated 2014-03-03 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your UAC (User Access Control) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is digitally signed by EWA Technologies, Inc..
Driver file size: 618880 bytes (604.38 KB)
This driver received an average rating of 4.5 stars out of 18804 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to install EWA Technologies, Inc. Blackhawk USB560 JTAG Emulator driver using DriverMax

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you find the EWA Technologies, Inc. Blackhawk USB560 JTAG Emulator driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.