Elnec BeeHive4, multiprogramming system - two ways of downloading and installing the driver

BeeHive4, multiprogramming system is a Dev Pgm USB hardware device. This Windows driver was developed by Elnec. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_1393&PID_0342.

1. Elnec BeeHive4, multiprogramming system driver - how to install it manually

1. Download the setup file for Elnec BeeHive4, multiprogramming system driver from the link below. This is the download link for the driver version 3.59.01.00 released on 2020-05-25.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be pretty straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.

This driver was rated with an average of 3.9 stars by 30025 users.

2. Using DriverMax to install Elnec BeeHive4, multiprogramming system driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's see!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you find the Elnec BeeHive4, multiprogramming system driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.