Driver for Atmel Atmel Touchscreen Digitizer - downloading and installing it

Atmel Touchscreen Digitizer is a USB human interface device class device. This Windows driver was developed by Atmel. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_03EB&PID_8A3C&REV_*&MI_00.

1. Atmel Atmel Touchscreen Digitizer driver - how to install it manually

1. Download the driver setup file for Atmel Atmel Touchscreen Digitizer driver from the link below. This is the download link for the driver version 1.8.2.0 released on 2015-12-15.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, it is as simple as that.
8.  

This driver is digitally signed.
Size of this driver: 15060 bytes (14.71 KB)
This driver received an average rating of 4.3 stars out of 41792 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 7 32 bits
• This driver works on Windows 7 64 bits

2. Using DriverMax to install Atmel Atmel Touchscreen Digitizer driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Search the list until you find the Atmel Atmel Touchscreen Digitizer driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.