Driver for Atmel Atmel Touchscreen Digitizer - downloading and installing it

Atmel Touchscreen Digitizer is a USB human interface device class hardware device. The developer of this driver was Atmel. USB/VID_03EB&PID_8A2C&REV_*&MI_00 is the matching hardware id of this device.

1. Atmel Atmel Touchscreen Digitizer - install the driver manually

1. Download the setup file for Atmel Atmel Touchscreen Digitizer driver from the link below. This download link is for the driver version 1.8.0.1 dated 2014-08-13.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is digitally signed by Atmel.
The file size of this driver is 14068 bytes (13.74 KB)
Driver rating 4.1 stars out of 17293 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 7 32 bits
• This driver works on Windows 7 64 bits

2. How to use DriverMax to install Atmel Atmel Touchscreen Digitizer driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's take a look!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Atmel Atmel Touchscreen Digitizer driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.