Alps Electric Alps PTP Config Filter - two ways of downloading and installing the driver

Alps PTP Config Filter is a USB human interface device class device. The developer of this driver was Alps Electric. The hardware id of this driver is HID/ALP001E&Col03.

1. Alps Electric Alps PTP Config Filter - install the driver manually

1. Download the setup file for Alps Electric Alps PTP Config Filter driver from the location below. This download link is for the driver version 8.2206.1717.1006 dated 2018-04-13.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is running then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be quite easy to follow. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, it is as simple as that.
8.  

This driver is digitally signed by the manufacturer.
The file size of this driver is 890455 bytes (869.58 KB)
This driver received an average rating of 4.1 stars out of 9806 votes.
This driver will work for the following versions of Windows:

• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. Using DriverMax to install Alps Electric Alps PTP Config Filter driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's see!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Alps Electric Alps PTP Config Filter driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.