Driver for Hamrick Software Agfa SnapScan e10 - downloading and installing it

Agfa SnapScan e10 is a Imaging Devices device. This driver was developed by Hamrick Software. In order to make sure you are downloading the exact right driver the hardware id is USB/Vid_06bd&Pid_2093.

1. Install Hamrick Software Agfa SnapScan e10 driver manually

1. Download the driver setup file for Hamrick Software Agfa SnapScan e10 driver from the location below. This is the download link for the driver version 1.0.0.6 released on 2006-08-21.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty easy to follow. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

There is no digital signature available for this driver.

This driver was installed by many users and received an average rating of 3.3 stars out of 48376 votes.

2. How to install Hamrick Software Agfa SnapScan e10 driver using DriverMax

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Hamrick Software Agfa SnapScan e10 driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.