Driver for Blackmagic Design ATEM 1 M/E Advanced Panel 10 - downloading and installing it

ATEM 1 M/E Advanced Panel 10 is a MEDIA hardware device. The developer of this driver was Blackmagic Design. The hardware id of this driver is USB/VID_1EDB&PID_BDEB; this string has to match your hardware.

1. How to manually install Blackmagic Design ATEM 1 M/E Advanced Panel 10 driver

1. Download the driver setup file for Blackmagic Design ATEM 1 M/E Advanced Panel 10 driver from the location below. This is the download link for the driver version 9.2.1.0 dated 2023-09-20.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.

This driver was installed by many users and received an average rating of 3.1 stars out of 95005 votes.

2. How to install Blackmagic Design ATEM 1 M/E Advanced Panel 10 driver using DriverMax

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's take a look!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Blackmagic Design ATEM 1 M/E Advanced Panel 10 driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.