National Instruments AT-GPIB/TNT Plug and Play - two ways of downloading and installing the driver

AT-GPIB/TNT Plug and Play is a GPIB device. This driver was developed by National Instruments. The hardware id of this driver is *NICC600; this string has to match your hardware.

1. Manually install National Instruments AT-GPIB/TNT Plug and Play driver

1. You can download from the link below the driver setup file for the National Instruments AT-GPIB/TNT Plug and Play driver. The archive contains version 3.0.0.49152 dated 2011-10-13 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is not digitally signed.

This driver received an average rating of 3.5 stars out of 21474 votes.

2. Installing the National Instruments AT-GPIB/TNT Plug and Play driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you find the National Instruments AT-GPIB/TNT Plug and Play driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.