3Dconnexion 3Dconnexion SpacePilot PRO - two ways of downloading and installing the driver

3Dconnexion SpacePilot PRO is a USB human interface device class device. This driver was developed by 3Dconnexion. In order to make sure you are downloading the exact right driver the hardware id is HID/Vid_046D&Pid_C629&MI_01.

1. 3Dconnexion 3Dconnexion SpacePilot PRO - install the driver manually

1. You can download from the link below the driver setup file for the 3Dconnexion 3Dconnexion SpacePilot PRO driver. The archive contains version 1.0.0.0 released on 2010-04-07 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver was not digitally signed.
Size of this driver: 0 bytes (0 B)
This driver was rated with an average of 3.2 stars by 91748 users.

2. The easy way: using DriverMax to install 3Dconnexion 3Dconnexion SpacePilot PRO driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Search the list until you locate the 3Dconnexion 3Dconnexion SpacePilot PRO driver. Click the Update button.
4.  
5. Finished installing the driver!
6.