Allied Telesis K.K. CG-WLCB300AGN - two ways of downloading and installing the driver

CG-WLCB300AGN is a Network Adapters hardware device. This Windows driver was developed by Allied Telesis K.K.. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_1814&DEV_0601&SUBSYS_C12A1259.

1. Allied Telesis K.K. CG-WLCB300AGN - install the driver manually

1. Download the setup file for Allied Telesis K.K. CG-WLCB300AGN driver from the link below. This is the download link for the driver version 3.02.03.0000 released on 2011-08-11.
2.  
3. Run the driver setup file from a Windows account with administrative rights. If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the new driver, it is as simple as that.
8.  

This driver is not digitally signed.

This driver was rated with an average of 3.4 stars by 81117 users.

2. How to install Allied Telesis K.K. CG-WLCB300AGN driver using DriverMax

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's see!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the Allied Telesis K.K. CG-WLCB300AGN driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.